xy program using level and density

im struggling

what does "

Indicates the programmable hysteresis; this value will be positive or negative depending on

Indicates the programmable hysteresis; this value will be positive or negative depending on

the entered condition."

mean

The problem i have is that when the density sensor is at a value say 1.024 and it switches between 1.0240 and  1.0239 then my pump keeps switching on and off...

i wasnt sure what the other value is which could be set .

Hy byronm,

the delta you can set with the density module is the one in the XY program, if the value changes rapidly between 1.0240 and 1.0239 and the level is low the program will give the start to the pump, this as programmed.

In this case the only thing can rise the 1.0239 value is to add salt water, are you using 2 different reservoir (salt and not water) ?

Bye